X-240240 gallon Expansion Tank, 150 psig, ASME$2,146.00
WATER TANKS
TECHNICAL SPECIFICATIONS

These Hanson lined potable hot water storage tanks are built and tested in accordance with the A.S.M.E. Boiler and Pressure Vessel Code Section IV for potable hot water storage tanks and bear the “HLW” stamp, and serial number, national board number as required. A copy of the A.S.M.E. data sheet HLW-6, signed by an A.S.M.E. authorized inspector, will be sent with the invoice if requested at time of order.

Standard exterior paint system is power buff to SSPC-SP3 plus one coat 2/3 MIL DFT rust resistant primer. Standard interior finish is fired porcelain enamel, aka “GLASS”.

All tappings and flange openings are plugged and covered before shipment. Manway covers are installed for shipping only, and must be adjusted and tightened before the tank is pressurized.

Sacrificial magnesium alloy anodes are shipped loose with all glass lined tanks for installation at the jobsite. These must be checked periodically in service and replaced if necessary to protect the tank lining.

The A.S.M.E. name plate and the supplied lift lugs are installed to allow clearance for tank insulation, which is available at extra cost.

Water storage tanks are guaranteed free from defects in material and workmanship for one year from the date of shipment, FOB our factory. Full limited warranty terms are available on request.


240 gallon Expansion Tank, 150 psig

BACK TO EXPANSION TANKS